Reparación y mantenimiento de ductos de fluidos en el lote x Petrobras por proceso SMAW
No Thumbnail Available
Date
2023-07
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Universidad Nacional de Trujillo
Abstract
El trabajo realizado tiene como finalidad analizar el proceso de
mantenimiento y reparación de ductos en el lote X de PETROBRAS desde las
inspecciones realizadas alos diferentes oleoductos, posteriormente su evaluación,
factibilidad hasta los cambios de tramos con tubería nueva, así también como el
reforzamiento de ductos en quebradas, comportamiento y demás protecciones
realizadas según su programa de integridad de ductos la cual consistió una vez
determinados los tramos a cambiar segúnel informe realizado al ducto a intervenir
se procedió a ubicar la tubería en los diferentestramos ubicados y se comenzó a
realizar los prefabricados de acuerdo a la cantidad detubos que se requirió cambiar
se buscó la zonas bajas para instalar las tinas o depósitospara la recepción de
fluidos, ya teniendo eta condiciones se programó la fecha de la intervención
movilizando y teniendo todas las facilidades en campo el día de la intervención de
hizo un bombeo de agua por el ducto a intervenir para desplazar el hidrocarburo
de este ducto luego se cerró las válvulas de los extremos de la línea y se instalaron
platos ciegos en estas para evitar el pase de hidrocarburos a la línea ,ya cerradas
y bloqueadas estas válvulas se realizan los cortes en frio en los puntos dondese
ubicaron las tinas para recibir el remanente del agua bombeada que quedo en la
líneacon el apoyo de cisternas se tomó una prueba de explosividad para verificar
las condiciones y así iniciar los cambios de dichos tramos haciendo los cortes en
caliente yel soldado de la tubería mediante el proceso SMAW para entregar el
ducto una vez terminada y probada el ducto se retiran los platos ciegos y se volvió
a poner en servicioeste ducto.
Description
He present work has been developed with the objective of describing the process
of maintenance and repair of pipelines in block X of PETROBRAS from the inspections
carried out on the different pipelines, later their evaluation, feasibility up to the changes
of sections with new pipelines, as well as such as the reinforcement of pipelines in
streams, support and other protections carried out according to its pipeline integrity
program, which consisted once the sections to be changed were determined according
to the report made to the pipeline to intervene, the pipe was located in the different
sections located and The prefabricated elements began to be made according to the
number of tubes that needed to be changed. The lower areas were sought to install the
tubs or tanks for the reception of fluids, and having these conditions, the date of the
intervención was scheduled, mobilizing and having all the facilities in the field on the day
of the intervention, water was pumped through the pipeline to in intervene to displace the
hydrocarbon from this pipeline, then the valves at the ends of the line were closed and
blind plates were installed in them to prevent the passage of hydrocarbons to the line,
once these valves are closed and blocked, cold cuts are made in the points where the
tubs were located to receive the remaining pumped water that remained in the line with
the support of cisterns, an explosion test was carried out to verify the conditions and thus
initiate the changes of said sections by making the hot cuts and the welding of the pipeline
through the SMAW process to deliver the pipeline once the pipeline is finiese and tested,
the blind plates are removed and this pipeline was put back into service.
Keywords
Reparación y mantenimiento de ductos de fluidos por proceso SMAW